Vegan Energy Bites
Medium
Makes: 54
  • Good to go
  • Long shelflife
  • Healthy
These vegan chocolate bites are made with two different layers. The first one features nuts, seeds, and dried fruits. The second layer is pure hazelnuts with chocolate. This creates a nice balance, not too sweet nor too strong.
These vegan chocolate bites are made with two different layers. The first one features nuts, seeds, and dried fruits. The second layer is pure hazelnuts with chocolate. This creates a nice balance, not too sweet nor too strong.
Shelf life:
60 days
Conservation:
Between 12°C - 18°C
Containing: 4 Components
Demonstration video<span>Vegan Energy Bites</span>

Chocolate Base

Ingredients: Chocolate Base

Preparation: Chocolate Base

  1. Pipe a dot of pre-crystallized chocolate on each corner of the plastic board and stick a guitar sheet on the board.
  2. In a bowl, mix the pre-crystallized chocolate with the grapeseed oil.
  3. Spread this chocolate mixture on the guitar sheet in a thin layer.
  4. Place a plastic frame on the chocolate and press down lightly to glue it to the guitar sheet. Allow it to set at 12ºC (54ºF) for 5 minutes or until set.

View tools

  • Stamp (s)
  • Scissors
  • Bowl(s)
  • Offset spatula
  • Mixing bowl (s)
  • Guitar sheets
  • Paper cones
  • 31 cm x 20 cm x 9 cm frame
  • Plastic board

Hazelnut Gianduja

Ingredients: Hazelnut Gianduja

Preparation: Hazelnut Gianduja

  1. Remove the parchment paper from the frame.
  2. Pipe a line of chocolate all around the frame and stick the second frame to it by pressing down.
  3. In a bowl, mix the melted chocolate with the nut paste.
  4. Pour the mixture onto the counter and temper it with a metal scraper and offset spatula to 25-26ºC (77-79 ºF).
  5. Mix until it starts thickening.
  6. Transfer the gianduja mix to the frame and spread it evenly.
  7. Sprinkle with the crushed hazelnuts.
  8. Cover with a guitar sheet and roll to even the top.
  9. Allow to set at 12ºC (54ºF) for one hour.

View tools

  • Scissors
  • Bowl(s)
  • Offset spatula
  • Mixing bowl (s)
  • Rolling pin
  • Paper cones
  • Metal Scraper
  • 31 cm x 20 cm x 9 cm frame
  • Prepared frame
  • Spatula(s)

Unmolding and Cutting

  1. Once the gianduja is set, remove the guitar sheet and then cut around the frames and remove them carefully.
  2. Cut your chocolates using a 3 cm (1.2”) pastry ring. You should get 54 pieces of chocolate.

View tools

  • Knife
  • Parchment paper
  • Gloves
  • 4 cm metal ring

Hand Dipping

Preparation: Hand Dipping

  1. Place the precrystalized chocolate in a large bowl.
  2. Warm the dipping fork with a heat gun.
  3. Place a piece of chocolate candy in the pre-crystallized chocolate. Push it down slightly so the sides are dipped but not the top.
  4. Place the dipping fork under the chocolate and move it up and down a few times to remove the excess chocolate from the sides.
  5. Scrape the extra chocolate from the bottom of the candy on the side of the bowl and place the chocolate piece on the transfer sheet.
  6. Let the chocolates set for at leat 20 minutes at 16-18ºC (61-64ºF).
  7. Once set, remove them carefully from the transfer sheet.
  8. Store the finished chocolates at 12-18ºC (54-64ºF) until needed.

View tools

  • Gloves
  • Mixing bowl (s)
  • Heat gun
  • Dipping fork
  • IBC Transfer Sheet

Facing Problems with your Creations?

  • Find troubleshooting guides & tutorials
  • Chat live with an advisor chef and find the right solution to your challenges